ICE in BHO open blast

[GroovyOctopusLabs]

Cured Badder Tek

Been running into some challenges getting a traditional wet looking badder consistency from dried/cured material. I’m able to achive solid badder style results on live material consistently but for some reason all the dry trim runs even when using great starting material end up looking very shiny, sticky, and extremely tough to whip and eventually transfer out of the pyrex. I’ve looked over the site alot and the badder tech is fairly consistent. Here is my procedure: Current Extraction Detail…

Badder tek

Hey everyone, I’m interested in trying out a badder for my next run. Is there an agreed upon purging method to get a nice, wet consistency? I will have live runs, and dry runs. Right now my plan is to run cold and fast (n2 push), and pour it into a mason jar. I plan to let it off gas for a bit, then throw it in the oven under full vac and ~90 degrees till its about to muffin. Then whip it (whip it good). After the first whip, I plan to put it back in the oven at full vac, buy maybe only ~75 degr…