I am wondering if anyone would share plumbing plate ideas that would go into a C1D1 room for water, vacuum pneumatic air, drain etc… Is there an option available to purchase out there anybody knows of? I’ve searched and searched and cannot find anything on the subject. If you have any DIY ideas please share pictures.
It’s what we used.
Super friendly customer service too
2 Likes
Fucking PROPER!!!
Any modifications to the enclosure need to be on the cut sheet that was signed off by engineer. When you modify it you void the stamp
2 Likes
Not mine, just a previous position 
This is a professional 9 booth install done by both ETS and 3rd party engineers.
1 Like
Still proper! Shit looks nice, and is a great example to run with!
1 Like
Thank you this is very helpful.
Thank you
Bulkhead fittings. This is pretty much exactly what they’re made for. Make sure they’re properly bonded if they’re the type with a rubber washer
2 Likes
Who makes that booth? My first extraction job utilized the same booth and the name escapes me
This. Or if you want to maintain an insulation envelope all the way you can leave about 1/8 or 1/16” around the pipe penetration, blast it with fire foam, trim the dry foam and then fire caulk.
Be accurate with cuts and measures or pay the price.
2 Likes