Does this count?
14 Likes
Is ‘too much’ a proper answer to that? 
But dude holy shit, IMPRESSIVE!
5 Likes
In goes the material!
8 Likes
More! We want more!
6 Likes
Dry Material coming out of the secondary solvent removal post decanter!
6 Likes
Impressive until you actually use their equipment. I was not happy with any of their gear I used. Had the extractor, filtration skid, and FFE. Welds are pretty, but that’s about all I liked.
2 Likes
Oh its you again…
Remember last time we chatted, you were upset over how the customer setup the equipment due to MAQ restrictions? We went over this well over a year ago, I even spoke to you on the phone If I remember correctly?
The company you worked for had a MAQ of 120 Gallons due to not building the room correctly. I would be upset with any equipment also if I was limited to 120 gallons.
That is some nice tube work right there! Badass!
1 Like
Solvent limits at the facility were never my issue with the equipment. Underperforming extraction efficiency, cannabinoid laiden tincture inevitably spread over the floor from removing bags, inability to graduate/stage filtration, chasing leaks in the ffe made worse with excessively overtightened clamps, etc, etc, etc.
I’ve been able to run plenty of gear, both Chinese and domestic, without issue, even with less than 20 gallons of alcohol to work with. The equipment was the issue, not the booze (of which 250 gallons or more was usually on site despite it being against code).
I had a piss poor experience with Pinnacle, and because of it, I will always like be vocal with my concerns.
6 Likes
I respect your opinion. When you design and build equipment at the start of an industry, it evolves over time through using technology that benefits while being able to afford more advanced technology.
There is never 100% of satisfied customers. That satisfaction is tied to many variables with how a facility runs, the infrastructure they have, and the products they are trying to create.
I specifically remember speaking to you on the phone after last time you voiced your opinion and you were very upset with how the facility built out the room as well as some issues with the equipment that we discussed in length.
We never had an FFE, we specifically designed and built a RFE. Which that Rising-Film design has recovered millions of gallons of solution without many issues for over 100 customers.
Again, everybody has an opinion, and I respect that. Cheers!
2 Likes
LS Powered and still front wheel drive? lol I bet that thing is a riot!
2 Likes
Torque-Steer City! Still sounds like a lot of fun! lol
My buggy is LS Powered, the Mini Death Kart I gave away. It was a supercharged 4 cylinder…maybe 160-ish hp
2 Likes
Now imagine sticking that same 5.3 into a miata… Whatever tread you start with on your tires, would be a distant memory by the end of a tank
1 Like
How much you think the mini death kart weighed? 160hp is a lot if it’s only moving 1000lbs around.
I think it scaled at 12xx pounds
That handle design reminds me of a zippo I used to have.
I would’ve put that on the inside. I feel like unless you’re smoking over parchment for it to drip on then it’s kind of a waste to coat j’s with concnetrates on the outside.
I’ve got 3 oz in bubble next to me, I’m ok with making mistakes.
Also the hash soaked into the joint via me warming it up with a hair dryer then the extra layer of hash i rolled it in kept it there.
1 Like