Nice 
Much luv, bruv
I keep trying to buy one from you! Whatâs the lead time? Letâs do it!
For me i have to purge super low temp for shatter. I pull a super slow muffin at like 92°f then after itâdrops I drop temp to 82° and purge for like 4-5 days flipping once to twice a day. If any of my oil touches anything over 100° It nucleates under vacuum and sugars within an hour.
I only experience that when I dont dewax thoroughlyâŚit will sugar up at high tempsâŚcould also be if u scrape the last of the pour out and add it to the slab
This is awesome
Someone asked about checking the pH of your concentrate
If inrenember(Iâve never had a real chemistry class) the way you check the pH of an oil or np solvent is to mix with distilled water, separate, and test the pH of the water.
So much to respond to but I forgot most of what I wanted to say so back to rereading
Take ph of some 96% ethanol
Take same amount of oil ad to ethanol and take ph
Gives a fairly good indication
Thank you!! Now I can figure out of if t-41 is actually changing my ph and if ph is related to stability!
What do you mean by this? Wouldnât the ph of the alcohol throw off the reading for the ph of the extract?
That is why you take a reading before of the etho to see how neutral it is normal etho is around 6.5 /7.5 ph
If the etho Isn t neutral then it wonât give a good reading
Same with water water can also. Have ph swings but will not mix thoroughly with your oil
I donât know Iâve always had this problem until I turned my oven temps way down. Even back when I was dewaxing open blast through a BĂźchner funnel with -65°f oil going through, it was definitely properly dewaxed and still sugared if over 100°f. I donât dewax since I switched to CLS. I just run cold temps, like -40 to -50°f. But if I keep my temps low I rarely get sugar.
Hereâs some current runs all with the same ratio of 100g each of silica, t5, and activated alumina. I did one run without any remediation, just a very cold/filter plate run like I would typically do for reference. All different strains but same age trim from the same grower. 4x48 columns
That looks fire!
Did someone try this in pentane? I see Roguelab saying it works. I tried in heptane & wasnât impressed so farâŚ
Breaking dabs did it on ig
Iâm struggling trying to figure out how to post a video on here. Any thing I need to know to make it work?
could be an OE interface
Pentane works better than hexane or heptane
But if extract is not gold from start
There is this red amber when extracted with room temp hexane that doesnât get out for now
Waiting on some more powders to arrive