I checked out the k4, but I haven’t run across anyone who operates one to get an idea on the pros and cons. Have you ran a k4 before?
K4 is good but depends on the output you need for filling.
1 Like
Ask these folks?
2 Likes
I’ve ran multiple Cf-K4s for 3 years now. Not only is it 3-4 times faster/efficient than the 40k paperweight I bought from vapejet but it also fills every profile imaginable with ease.
Filled a couple million units with the cart farms and keep coming back time and time again.
3 Likes
Do you have any leak issues with the CF-K4? I had so many issues with the CF1000s I bought constantly leaking. Rebuilding the syringe unit was kind of a pain in the ass. I have a VJ and truthfully had minimal issues with it in 2+ years but it’s extremely expensive so getting an additional unit to ramp up production isn’t feasible.
2 Likes
I have had zero issues with my jet fueler
Where is it leaking from? Where the mondo line screws into the res, where the syringe screws into the adapter/line, or elsewhere?
Redacted
fuck vape jet and their original owner
2 Likes
Really? If so that was quick.
2 Likes
My bad, I missed this. Where where the cf1000’s leaking from? There are 3 spots that can leak:
The tube where it attaches to the fittings, the washer inside the barrel, and where fittings attach to either the dispenser or the reservoir.
The solution for the tube is to push it in further after heating up the fitting. Many times people will half-seat the tubing. The solution for the barrel washer is to disassemble the dispenser and inspect it. If its ok, reassemble. For the fittings, simply tighten them.
If you are leaking from the nozzle it means you need to clean the machine, simply tun isopropyl or ethanol through the machine.
2 Likes