I’m thinking you’re right, but I’ve heard it smokes poorly. Ordering some to test regardless.
it smokes fine, we do a thca infused cannabis preroll and its burn is no different than a regualr preroll.
1 Like
Everyone can get THCa products right now if they have the internet. No need to hide trim in a pre roll. That’s just dirty business practice.
Nice. How do you blend it in evenly? Is there really a special grinder for it?
not really anything special, just put thca in the already ground trim and then tumble it around. our rpd has been pretty consistent.
1 Like
One of my first jobs I had to chop massive amounts of parsley with a chefs knife on a cutting board
Get to work Chef
1 Like
I like the trim of sugar leaf thats right on the bud.
Either the Futurola or the High-Tech shredder would work to prevent decarb. Personally recommend the High-Tech. Same basic design at a lower cost and as long as you keep them clean they’ll last the same amount of time so might as well save some money. We’ve gone through literal tons of material with one of these with no decarb issue. You will have to play around with your grind times to find what works best for your material in terms of getting it to preroll consistency but it shouldn’t take you more than 15min. to dial it in. We usually do 7-15sec pulses with the motor while tumbling and as long as your material is dried properly it should break up perfectly. Dump it over a screen to filter out any remaining stick material and start rolling! 7lb Shredder
Bigger bowl, bigger stick.
Just the right amount of liq N2.
Ventilation so you can breathe.
Once upon a time I used to free bicycles using liq N2.
Takes several min to freeze the lock, and requires a boat of some sort to contain it once it stays liquid.
Then one smack with a hammer and it’s done.
1 Like