New to make* diamonds

[StoneD]

let me wipe the dust off these for you good sir

Only The Strong sauce tek

Start by chilling your material columns. With open sleeved jackets a dry ice/ 99% isopropyl solution will reach -110, and with closed jackets liquid nitrogen is appropriate. Chill the solvent tank at this time as well. Once you have reached and are holding desired temp while also maintaining vacuum it’s time to prime the system. We do this by pushing warm vapors from another solvent tank into the system. Turn on your recovery pump and open recovery port on your cold tank, allow it to build a bi…

Or this tek is great for BEGINNERS

No crc powders needed. just freeze everything with dry ice,. Material, solvent, everything froze on dry ice prior to running! BLAST FAST AND COLD
Then proceed with hot jar tek
only reason it wouldn’t work is either ur material is old as fuck and naturally decarbed. Or you didnt freeze w dry ice, material and solvent too!

Crc diamonds hot jar tek

start with your SOP for regular crc extraction I run a coil prior to injection i have ran room temp solvent with decent result . I just run regular ice in the coil for a happy cost effective middle ground instead of dry ice . Temp gun says solvent gets between 0-5 F For indoor i use 1 cup B80 per pound , light dep or really high end outdoor 1.5 cups , and 2 cups for regular outdoor or aged older material followed by a thin layer for celite below the B80 to prevent powders slipping through. I …

SPOON OF THE DAY

Btw the search bar works wonders around here. This is only the Umpteenth thread about this