I’m telling ya…
4 Likes
All the new iPhone users have full 5G signal inside the lab and nowhere else, Lmao. That would be sketchy shit if it was the case.
3 Likes
Frequency is frequency
It’s all about signal strength after that
If you have seen what changing HZ on a sub woofer does to sand patterns it makes sense
4 Likes
That’s exactly where my heads at. This is weird as fuck
2 Likes
7 Likes
Either way I now want to put jars on subwoofers at different frequencies and see what happens
9 Likes
If youve been to any labs in coachella valley youd probly change your mind on frequencies my last one had a 15×40ish stainless container, 20 ovens stacked rotovape wiped film and ultrasonic cleaners within 20 feet of each other. Never experienced the issue. Coachella labs was like this as well but have moved into their new location.
Most the original type 7s in cali looked more like trap labs than trap labs lmao.
Speaking on equipment frequencies. I havnt read nearly enough into 5g to speak on that lol
1 Like
Aliens are making crop circles using cymatics and it’s fucking up our diamonds
5 Likes
From what I’ve read it has to do with cooling pattern and supersaturation levels. The ones I had I put on heat and they redissolved back into smaller shapes due to the added heat. Once they cooled they stalled for a few days but then started going again in normal shapes now.
Check this out
17 Likes
The distillate we just used as a carrier to test raw undistilled gas. Just shot a bunch into the jar mixed it up and sent off to test as we haven’t found a solution for testing the tanks straight up.
1 Like
I know you’ve said your process hasn’t changed, but just want to be sure… are you recovering faster now, then you were in March? (Changed pumps, rebuild, more heat?)
We are recovering slower than in March. The past month we knocked down the heat on our collection. We are recovering probably 15-20% slower but thats the only change in our SOP since March
Do you have a link to this?
Yes I do
Just copy and paste this in the sci-hub.se site to get acces to it. Here it is:
3 Likes
Have you guys tried pouring them wetter and letting the crystals form slower?
Takes weeks on a wet pour and most of you guys have said these are being done in days
Maybe the solution is too saturated and it’s affecting the lattice
4 Likes
6 Likes
Anybody testing the ph of the solvent? Or the solution
Does solvent even have a ph?
Is crc media affecting the ph?
The blue stones are created using some sort of polarity shift. Could this be a factor
@TheWillBilly what are your thoughts on this and how would you go about troubleshooting it
Same batch and same pour into different miners yielded both stir bar shapes and pyramid shapes. Only difference was the cooling pattern
1 Like
Have you tried a wetter pour ie more solvent
Yea it makes cleaner crystals with really good clarity if you go heavier on solvent
2 Likes