yep.
Which is why I tried to point you at EVERYTHING you needed…
AND why it was left “some assembly required”…
Did you start at the top?
Did you follow the links?
Did you learn of “winterize”?
Explicitly: See if you have anything that is not soluble in cold ethanol/methanol/acetonitrile.
Use mass balance to understand how much fat you’re dealing with.
…but If you are spinning the hte off of the thca, you have already “filtered it a a fuge”.
The very fancy fuge linked would work…but nobody was suggesting you ought purchase one.
It would simply be one way of achieving the MWCO’s that would “filter” your fats and waxes out. The same membranes (1000 times finer than that “1um”) could be used without that fuge.
only way you are likely to have success is to use differential sedimentation (referred to as “pelleting” up thread and elsewhere)
You will see folks showing examples of that up thread.
You may find that it’s “fines” (thca) that pellets, and that any actual fats/waxes show up as a lower density layer at the TOP of your tube.
Using the scientific method (in this case 190proof ethanol) you can tell which of those are fats…
guess. Test said guess.
what does a “positive result” look like if you have no way to collect and measure the fats/waxes?
Same page yet?
