Something like this:
2 Likes
I knew it existed I’m just looking for so many different things, was being respectful, honest and in no way a smart ass when I asked. You know how it is when you think too hard about something and get tunnel vision. I think I will go this way so I can have the spray head not be offset to the side. 
Ty again my friend
1 Like
You can get the ones @710ST posted, as well there’s other companies that make them. If I go this route I think I’d go Swagelok. 
i have the 3" version , 2 ports, offset shower head, t on shower head , guauge and valve on open port, maybe overkill , dont need to change hoses, vent/purge, n2, solvent in,
no issues with it to speak of
1 Like
Check out ispray.com
I tried out these two:
I could not find any of them in compression fittings so I had to use some adapters and downtubes. Further searching or customization may be available.
2 Likes
wow, thats rad bro, is that what you use daily or ? did you like them?
I used them as a experiment for a custom small scale ETOH extractor. The flow rate is a damn garden hose. One creates a 53 degree angled cone, the other a 70ish degree cone.
2 Likes