More of a winter thing. I don’t use a jacket. So it just helps keep temp in. It works for sure.
But in summer months it fights my crc ,they not much help then u need jacket to maintain temp
With standard fast and cold run its perfect, freeze bud prior to loading. Load fast and go fast.
But w a CRC it slows the flow so bad that you will start to thaw and grab fats without a jacket
i grind with a leaf mulcher
You got a thermo well in your lid? I might just being seeing things lol
Definitely seeing things…i have a gauge and prv on the recover port,sight glass…the usual
It’s probably the adjustable prv that has port to hook hose up to in case it release
Lol it’s just my shitty service. I before the pic cleared up. I thought it was thermo well sticking out where your t and the long cork screw thing is.
Yeah the cork screw is behind the rig…that’s my secret for pulling material out at lightning speeds
The one you posted in the trick of the trade tread ???
Thats it I think someone else showed me here but I forget who
I’ve done it too. Neighbors called the cops cause of the dry ice vapors when I tried clearing the sleeve with warm water. They ended up wishing me good luck and didn’t come back.
Damn what state? Sounds like my type of party
Massachusetts
What the hell?
Ik @all I got fucking lucky
I assured them I’m not leaving the unit unattended and that closed loop is about as safe as it gets and that none of the solvent was leaving the area. I was scared shitless but I was calm, friendly (no bs I invited them to my yard with a oh, hello how are you) and explained everything that was happening. They were just there for the dry ice vapors (cause I poured water over the dry ice, no slurry. I was just trying to warm up the column cause I was getting towards recovery never making that mistake again) cause the neighbors got nervous.
Now, I currently run Ethanol only but in the summer I’m going back to Butane and most likely doing the ½ inch recovery lines to only be outside for 5 mins instead of 30 to an hr.
If you not maintaining a proper water bath it’s gonna be 30 min regardless
I found the paint mixer did the job.
worked on leaf, bud, trim.
was pretty rough on the drill 
I’m wondering if a corded drill is the right way to go for this?
This is dope bro
Just curious why you have reducer, filter plate, reducer instead of the column after the filter plate
I know why i. Use reducers
Silica60 is a powder that needs a certain thickness in the cake to work best by using a reducer the cake is higher with the same volume
So you can use less powder for the same thicknes as in a normal spool
How do i heat my “rack mounted” (I just say that because im a bit trashy and using 2×4s) active system? What kind of heating mats can I use? My recovery is garbage and I know it’s clearly from lack of heat.