Step 1. Hook up a crc to a 2in ball valve to a dewaxing column.
Step 2. Place material to be cleaned in dewaxing chamber.
Step 3. Add enough solvent to fully dissolve material and let it sit for 1hr.
Step 4. Chill dewaxing column after 1hr has passed whether it’s with a chiller or dry ice and let it chill for about 20min.
Step 5. Open valve slowly and push with nitro through crc into your collection chamber and recover.
10 Likes
What’s y’all best method of redissolving BHO into solvent? I’m always having problems getting it all dissolved…
2 Likes
Warm or room temp butane will do it at a 10 to 1 ratio in 1hr
4 Likes
Yea an open jacket 6x36 spool
1 Like
anything on the bottom? just right on the filter?
I’ve tried this with 600g of BHO and it took like 150lb of solvent to finally melt the whole thing.
1 Like
1 Like
Warm gas and extra pass’s
2 Likes
This is what worked for us. Just takes so fkin long…
1 Like
I had a nightmare weekend where I tried to shove old oil up and through a 1/4” line… rolled it up to 100psi… nothing.
I had to take my little 7lb gas tank from killa and completely submerge it in a 20 gallon trash can of hot water around 115° for 2.5 hrs… took 3 pass’s to get it all but I got it…
Only took 6 hrs total… 
4 Likes
Thank you all for the input… I’ll be reading more on the topic before
doing the task.
Since there is about 1/2 pound to test with… doing 2 to 4 ounces
at a time will be the test ground.
The crc material ratio is a guess at 30 grams each and if works, next
guess is to re-use same crc material up to 3 times? I recently ran 3 pipes
of flower 3 times with the same powders before the 110mm filter paper
gave out.
Open to suggestions …
hashyone
Are you melting tane into the product in the material column? When you say warm tane, do you mean straight from the bottle? Then add chilled to run through the system?
Warming up means 70f+ Or warmer, I was doing it about 105 and it was quick!, I put a black-ass slab in a little collection, added solvent about 9:1, heated it up, already pressure in there but added the N2 @50psi and pushed it thru the 4” crc (from @Killa12345 )
Def don’t run cold solvent when you’re trying to re crc oil. Won’t do you any good.
Straight from the bottle or warmed. Warming it is much faster.
I do it with a solvent tank that has a dip tube and sight glass
4 Likes
How long does it take? Thanks for the help bro.
Depends on the size of the thca.
Bigger chunks take more energy to melt down into the solvent
1 Like
You’re right about that. I started with just roughly 500g that had already sugared in a 25lb solvent tank equipped with a dip tube. It’s taking a long ass time.
Recover off the top of the tank. Bubble the resultant hot vapor back in via the diptube.
Re-dissolve BHO for CRC - #27 by Saucyslabz
(Maybe read the whole thread…now that you’ve already attempted the trick.)
1 Like
This is in a mini bhogart collection with some black-ass crude put in the bottom, water turned on, vac pulled, solvent injected….it warmed up and it dissolved quickly…added some n2 and pushed thru the crc, came out nicer