CAT Homogenizer for vg tincture

Which CAT Homogenizer do you have, and which Generator Shaft; G20 Fine, Normal or Coarse?

Is your BHO Winterized?

  1. Heat VG to 80C on your hotplate stirrer
  2. Heat BHO in another vessel so it’s pourable.
  3. Move the beaker with the heated VG over to the homogenizer, adjust shaft so its about 1/2 " from the bottom of the vessel.
  4. Adjust the beaker so the shaft is off center so you don’t create a vortex when emulsifying
  5. Power on the device and pour in the warmed BHO. Emulisfy for about a minute and half.
  6. Place the beaker back on the hotplate stirrer and heat solution to 80C for 1/2 an hour. (1/2 hour from the time the solution reaches 80C) You’ll notice some BHO falls out of solution in the center of the vessel.
  7. Homogenize the solution for another minute and a half.
  8. Reheat the solution to 80C for 1/2 an hour, (1/2 hour from the time the solution reaches 80C) you may still see some BHO fall out of solution.
  9. Repeat steps 6 & 7- You may have to do this three of four times until you don’t see any BHO fall out of solution.
  10. There’s no need to filter the solution.


X1000D Homogenizer


CAT MCS78 Hotplate Stirrer: Heat VG to 80C


Step 4


Reheating solution to 80C for 1/2 hour - BHO falling out of solution

7 Likes