Equipment I made myself several years ago during the medical days.
Welding was done by certified welders at Pro-sales in Tacoma, Wa.
These are parts only, not part of any certified extraction system, but defiantly better than the typical chinese parts.
Make an offer, they must be sold.
(2) 4x48" jacketed columns (USA welded)
(3) 3x36" jacketed columns (1 is fully set up as a condenser w? all swagelok hardware) (USA welded)
(1) 6x18" jacketed recovery vessel (along with all the parts to produce another) (USA welded)
(1) 6" recovery vessel lid with swagelok valves, gauge, and fittings (USA welded)
(1) 8x18" jacketed recovery vessel (USA welded)
(1) 8" recovery vessel lid (dual sight glasses, swagelok 3-way valves, swagelok pressure relief valve, swagelok 200psi gauge, thermocouple) (USA welded)
(1) 8" pouring platter
(1) 6" pouring platter
(3) 6x6" spools
(3) 6x12" spools
(2) 6" jacketed bowls with pour spout (1 with swagelok valve installed)
(4) 3x36" spools
(1) 4x24" spool
(1) 4x36" spool
(1) 3X24" spool
(1) 1 1/2" PTFE ball valve (made by VNE)
(20) thermocouple wiring fittings
Approx (40) viton gaskets in 1 1/2", 2", 3", 6", 8"
(12) thermocouple sensors (including (2) with built-in shielded wiring)
(2) 2-channel thermocouple readers
Approx (10lbs) 4a Molecular sieve media (used in condensers)
(6) 1/4" 2-way swagelok valves
Assorted swagelok fittings, ferrules, and weldements (the yellow & black parts cases)
Unfinished parts:
All necessary parts to produce an additional 6x18 jacketed column
All necessary parts to produce (2) sets of 4" column lids (pre-drilled)
All necessary parts to produce (2) sets of 3" column lids (pre-drilled)
Parts to produce (1) 6" recovery vessel lid (sight-glass lens is required)
All necessary parts to produce (1) 8" jacketed pour spout
Approx (8) DIN sight-glass fittings
Approx (25) single-pin tri clamps in 1 1/2", 3", 6", 12"
Approx (12) high-pressure tri clamps in 3", 4", 6", 8"
(3) sets of german-made uni-strut mounting hardware in 3"
Assorted water-jet cut steel parts (jacketed column ends, 6" pour spout bases, rack-mounting fittings)
6in_heated_cup_modification.pdf (80.4 KB) 8in_Dual_Sightlgass_lid.pdf (179.4 KB) ac1_4x48in_Jacketed_Spool_Assem.pdf (252.4 KB) AC0002.pdf (295.2 KB) AC0004.pdf (512.0 KB)
Uploading: 20150716_164632.jpg… Uploading: 20150804_133558.jpg… Uploading: 20150804_133602.jpg… Uploading: 20150810_065053.jpg… Uploading: 20150810_065116.jpg… Uploading: 20150812_172135.jpg… Uploading: 20150812_172143.jpg… Uploading: 20150812_172223.jpg…
