Hello, I am fairly new here and have been taking in all the information I could, after searching on and off for days and reading tons of valuable information I have found here I have a few questions.
If I start with a hemp BHO material in a SPD rig it seems as if it will still be out of compliance due to decarb of THCA and similar. This being said I would most likely have to pay for a remediation service of the distillate I produce as I most likely cannot do that in my small low capital lab. My question is is there currently any proper way to get that distillate compliant that one can do without tons of equipment or will I just get it down to the more then likely 4/5% THC numbers and not be able to use it without making it into a cut end product?
Thanks so much!
Remeditation, Conversion, and dilution are your only real options. Pick the one that fits your end product and budget and run with it.
What conversion method would be usable for either turning D9 into D8 or D10 or otherwise into CBD if possible? Any of these viable in a small lab or would I just focus on dilution at my stage.
Summit makes a spd 4 Bertha system that’s designed for cbd crude refinement.
And How can Dear bertha help this fellow taking 4-5% thc to complaint
Please do tell
Isolate? Maybe add a little mother liquor back to tune thc just below 0.2%
You don’t make an spd that’s gonna get that 4-5% thc out. I don’t think you can even do that with your fancy fraction finder, otherwise everybody and their momma would be using it instead of chromatography for remediation.
My spd can bring the percentage as low as possible compared to others. And yes there is really no distillation system that remove thc bc they come out together. You have to mechanically remove it prior.